Question: Has the FCC issued RF exposure guidance for an on-body device equipped with motion sensors to control its conducted power?...

Question: How should we proceed with respect to the Canadian certification for our wireless device following changes we’ve made to it?...

On October 4, 2023 at approximately 2:18 pm EDT, mobile devices throughout the United States and its territories will receive a test...

Personnel changes require that we update the contact information for our FCC Grantee Code that was registered many years ago. What do we...

On July 7, 2023 the Electronics Communications Committee (ECC) opened the following public consultations, accessible here and available...

On July 6, 2023, ANATEL published Ato No. 7971 approving the technical requirements to evaluate compliance for IPv6 protocol in...

The Department of Innovation, Science and Economic Development (ISED) in Canada published Radio Standards Specification RSS-192, Issue 5,...

On July 18, 2023, the Federal Communications Commission announced a proposal to create a voluntary cybersecurity labeling program to...

This is a shortened list of the new ETSI standards published during the past month: ETSI EN 303 687 V1.1.1 (2023-06) - (June 2023) - 6...

Question: Many of our certification applications contain some of the same technical documents we have submitted in support of prior...

Question: We want to FCC certify a new line of wireless modules that cannot be tested in a stand-alone configuration. How should we...

On October 29, 2019, the FCC released draft Order and Further Notice of Proposed Rulemaking as part of a "permit-but-disclose" ...

On August 22, 2019, the FCC issued an enforcement advisory in regard to several companies' interference with the Federal Aviation ...

The PCB designer is no stranger to EMC issues, especially the issue of crosstalk. Crosstalk is any undesirable signal transfer between ...

If there's one thing that PCB and EMC design have in common, it's that these designs are often left until the very end of the product ...

On August 26, 2019, the FCC issued a Protective Order, which establishes procedures to protect the confidentiality of information in ...

When engineers begin designing their products, electromagnetic compatibility is usually the furthest thing from their minds. EMC testing...

According to a survey conducted by Irdeto Global Connected Industries, 80 percent of organizations’ IoT devices have experienced...

In response to Executive Order 13859, on August 9th, 2019, the National Institute of Standards and Technology (NIST) released U.S...