Question: Has the FCC issued RF exposure guidance for an on-body device equipped with motion sensors to control its conducted power?...

On October 4, 2023 at approximately 2:18 pm EDT, mobile devices throughout the United States and its territories will receive a test...

Personnel changes require that we update the contact information for our FCC Grantee Code that was registered many years ago. What do we...

What is the deadline for adding the UKCA mark to our wireless products destined for the United Kingdom? At this time, there is no longer...

The Ministry of Industry and Information Technology (MIIT) of China issued a new version of the “Regulations on the Allocation of Radio...

On July 6, 2023, ANATEL published Ato No. 7971 approving the technical requirements to evaluate compliance for IPv6 protocol in...

The Department of Innovation, Science and Economic Development (ISED) in Canada opened a public consultation on the adoption of two ANSI...

The Department of Innovation, Science and Economic Development (ISED) in Canada published Radio Standards Specification RSS-192, Issue 5,...

This is a shortened list of the new ETSI standards published during the past month: ETSI EN 303 687 V1.1.1 (2023-06) - (June 2023) - 6...

Question: We want to FCC certify a new line of wireless modules that cannot be tested in a stand-alone configuration. How should we...

On May 17 2023 the Minister for the Digital Economy and Communications of New Zealand issued a Statement of Government Policy for...

On June 11, 2023, the Communication and Information Technology Regulatory Authority (CITRA) of Kuwait published Resolution No. 297/2023,...

When designing PCBs, various ways exist to achieve copper balancing and prevent warping during automated soldering. One common method is...

Question: Does ISED Canada have specific procedures for obtaining equipment authorization for software-defined radios, similar to the FCC...

The following are an example of steps to follow using signal integrity analysis software: Create a schematic of your power distribution...

Printed Circuit Board (PCB) interconnects to meet all regulatory standards, including MIL-STD-461F, must be routed to reduce noise,...

There are advantages and disadvantages to splitting a PCB power plane to meet MIL-STD-461G EMC limits. Some of the benefits split into...

When Printed Circuit Boards (PCBs) are not correctly designed, adverse electromagnetic compatibility EMC issues can occur: Poorly...

Section 20 of the RTCA/DO-160G standard is an equivalent test method to MIL-STD-461G, CS101 "Conducted Susceptibility, Power Lines and...

CS114 in Military Standard MIL-STD-461 G is a standard for military equipment, and compliance is required for equipment to be used in...